ALL NEW, JLT Cold Air Intake for 2018-2021 Jeep TrackHawk. Bad to the Bone all on it's own, but we make it better (and badder)!
This kit includes a roto molded plastic heat shield that has a opening in the front to grab fresh air from the grille/headlight area and also seals to the hood.
Our air filter is a custom built design made by S&B. It has a built in bell mouth for super smooth and fast air flow as well as huge 1" deep pleats for more surface area than filters that look much bigger.
The intake tube is roto molded plastic with a huge 5" filer opening for superior airflow and NO heat soak like metal tubes.
With a mouth of 4.5" at the throttle body end, it is ready for any larger throttle bodies that may come in the future.
Standard finish is an OEM looking black textured plastic.
Includes our large ABS plastic heat shield to block engine heat at idle and low speed.
It uses a large area to make sure the filter has tons of cool air and uses the factory fresh air inlet from the bumper to keep temps cool as stock
• JLT Roto Molded Plastic Intake Tube
• Silicone Reducer
• 5x7 S&B Powerstack Air Filter Red Oil
• JLT Roto Molded Heat Shield with fresh air feed
• HD Clamps, all needed hardware
GAINS AND TESTING
30-35 RWHP & 20-25 RWTQ are typical with this kit.
No tuning required
The design, detailed instructions and online video (see below) helps make this an easy install (see Instructions & Videos tabs to download / view).
To properly clean your oil filter, we recommend the S&B Precision II Cleaning & Oiling Kit.
*TIP* by purchasing a 2nd air filter you can simply swap filters when it's time to clean it and not be rushed. Clean the first filter and it's ready when it's time to change again.
JLT Pre-Filters are now available for most intake kits we carry, these filters are made for us by Outerwears, these prefilters are water repellent. They will increase your filter life and cut down on your cleaning intervals!
Have used JLT on a number of my cars, amazing fit and results will forever use JLT
Instructions easy to read, put it on in 45 minutes. Great cold air intake for the money, sounds great. It definitely woke up the super charger, and the throttle response is better. It gained some HP too. Would recommend this to anyone with a TH.
Great product. Easy to install. Love the way it sounds and the extra power.
JLT cold air intake was super easy to install on my 2018 Trackhawk. This product should have come from the factory it's so perfect! The additional supercharge whine is simply amazing. Strongly recommend this product.
I am so glad I did the install myself. I'm not even close to a mechanic and these were both purdy daggone simple. The whine after the install is awesome and everything looks oem. The videos on here are short and really help. Could have been a little more informative on the removal of those pesky clips that go on both, but I managed. Them being short and to the point is nice.
Simple install, well built, easily the best and first upgrade every trackhawk owner should do!
Install was fairly straight forward. The instructions and photos were close and helpful. There are a couple videos available. Like the product so far. Make a the supercharger sound even better. Throttle seems crisp and more responsive. Looks good but wish the tube came in carbon fiber. Excellent product. KIT customer service is first class and they actually respond.
Product works great. It really wakes up the Supercharge you can hear the whine
I purchased this intake based on the performance gains showed on the dyno. What I didn’t expect, is that it woke up my Trackhawk like you wouldn’t believe. Increased throttle response. 25 hp increase shown on the onboard dyno (however accurate that is). But the sound in track mode will have you smiling ear to ear. Catch can going in on Monday. Great fit, great performance, great purchase.