JLT BIG AIR Intake with HydroCarbon Finish for the 2010-14 GT500.
INTAKE TUBE WITH MOLDED IN MAF
The best part of this JLT Big Air is we kicked the cool factor up a notch and molded a 123mm MAF housing right in the tube. This makes a much smoother interior without any transitions, steps or couplers to upset the air flow. Another benefit is the over all look is just plain awesome! Early testing shows this can be used with the stock MAF sensor all the way up to 750 RWHP and well beyond with a MAFia, SCT BA5000 or HPX sensor.
Through an awesome process called Hydrographics, the intake tube is made to look like carbon fiber. The tube is painted and then dipped in a water solution with a carbon fiber print film that adheres to the part when removed. Tube is then clear coated for a durable finish.
The vacuum formed ABS plastic heat shield blocks engine heat at idle and low speed. It has a weather strip that seals to the hood, and incorporates the fresh air inlet from the grill. It uses a large area to make sure the filter has tons of cool air. Now includes new redesigned heat shield so 2013 GT500's no longer have to move the intercooler pump.(2/25/13)
We use only the best air filters made by S&B to our specifications. We love S&B's tapered flange design and Powerstack filtered ends. With a huge 5” opening on the tube we needed a huge filter. The result is a monster 5x9” filter with built in screen to straighten airflow. It measures a full 8.25” across at the base and 5.5” at the top.
OIL OR DRY
We use only the best air filters made by S&B to our specifications.
For years we only used oiled filters, but dry filter technology has been proven and is now a popular option.
Should I choose a Dry Disposable or Cotton Oiled Filter?
Since you are not sacrificing performance with either choice, the decision comes down to would you rather throw away the filter or clean it.
Comparable airflow to oiled cotton filters with the same great protection.
Last for up to 30,000 miles of highway driving. Extend the life of the filter using compressed air.
Oiled filters can last forever as long as you properly clean and re-oil it.
See picture of filters below. Oil filters are available in red or blue and Dry filters are white.
A JLT specific tune is required with this kit.
The design, detailed instructions and online video instructions helps make this an easy install.
•JLT Plastic Intake Tube with Hydrocarbon finish
•5x9 S&B Powerstack Air Filter
•ABS Heat Shield
•HD Clamps & all needed hardware
JLT Pre-Filters are now available for most intake kits we carry, these filters are made for us by Outerwears, these prefilters are water repellent. They will increase your filter life and cut down on your cleaning intervals! For more information check the product page here JLT Air Filter PRE FILTER
To properly clean your oil filter, we recommend the S&B Precision II Cleaning & Oiling Kit.
*TIP* by purchasing a 2nd air filter you can simply swap filters when it's time to clean it and not be rushed. Clean the first filter and it's ready when it's time to change again.
*Tuning is required*
*This product is NOT CARB (California Air Resource Board) Exempt. It is not for legal sale or use in the state of CA or any other states adopting CA emission standards and require a CA Executive Order (EO) number. Any orders placed for this item with a CA ship to address will be cancelled.