A must for auto X and Road course cars
During hard racing the fluid in the rear end heats up and expands. Combine that with extreme cornering and the fluid can spit out of the factory breather vent and all over the track. With our Expansion take, the...
Made from 1/8" thick ABS plastic. Mounts using existing holes NO DRILLING. Precision cut on a water jet. All new hardware included. Designed to match the body lines of each car.
Something new we're doing at JLT, splash guards. We have...
JLT BIG Air Intake Kit
BIG AIR INTAKE TUBE WITH MOLDED IN MAF The best part of our Big Air intake is we kicked the cool factor up a notch and molded a 123mm MAF housing right in the tube. With no separate MAF housing or couplers air flow is fast and...
Package includes JLT Big Air Intake Kit, SCT X-4 Power Flash Tuner loaded with Custom Tunes, JLT T-Shirt, and Free Standard shipping to Continental US. PULLEY PACKAGE OPTIONAL
INTAKE: BIG AIR PLASTIC INTAKE TUBE WITH MOLDED IN MAF The best part of our...
Redline Tuning Bolt-in QuickLIFT Systems 2005-2014 Ford Mustang Hood QuickLIFT PLUS & QuickLIFT ELITE
This is one of the FIRST mods we do to our shop cars here at JLT!
Replace your hood's prop rod today with the Redline Tuning Hood QuickLIFT...
RECOMMENDED FOR CARS 800 RWHP AND HIGHER
NEW TUBE DESIGN All new and thick, roto molded plastic tubes. A full 5.5" at the throttle body to mate up with the huge KB twin 75mm throttle body and 6" at the filter. It also has a new larger heat shield with...
JLT Pulley package
This is all the parts needed to upgrade from your JLT Intake and tune to a full JLT Intake and Pulley package. If you purchased your JLT intake and tuner kit from us, JLT PERFORMANCE, it came with a pulley tune pre programmed in your...
SCT X4 Power Flash Handheld Programmer, SCT part# 7015, Most 1996-2017 Ford Cars & Trucks - Gas & Diesel
Increases Horsepower & Torque! The X4 Power Flash arrives Pre-Loaded with DYNO Proven tune files that INCREASE...
Finish off your brake cooling kit with these Grille Bezels from JLT Performance. These bezels are milled from solid billet aluminum with a nice lip and smooth radius on the inside and outside edges. We made the outer lip a little wider to stand out more...
This clever piece attaches to the snout of your supercharger, and adds a bit of flash to a very visible part of the engine.
It installs in place of the plastic pin installed by the factory at the end of the suopercharger shaft. The included stainless...
Bring cool outside air to your JLT CAI filter system on your GT500 with this new Fresh Air Kit. Behind the lower grille on all GT500’s, Ford put provisions for the future install of a brake cooling kit. Simply drill out the grille from the back...
JLT's newest product brings in cool air just like our intake systems, but this kit is for your brakes. Anyone who has done any Autocross, SCCA, road coarse or even heavy on road braking knows how important it is to keep your brake rotors cool. This kit...